Need Sales Help?

Huge Sale
Expires 7/22/2014!

Installation of Glued-Down Cork Flooring

Posted: 01 JUL 2002

Cork flooring tiles are manufactured in 12-inch squares and are mounted to the sub-surface with flooring adhesive. They can be installed directly onto concrete slabs or over secure wood sub-flooring. Some flooring manufacturers recommend hardboard for glue-down installations, so be sure to follow your manufacturer’s advice.

Regardless of the sub-surface, the preparation requirements are the same. The sub-surface must be clean, dry, smooth and level. The following information provides some typical steps involved with sub-surface preparation of concrete slabs and wood sub-flooring.

Preparation for installation on concrete:

  • Patch any cracks or holes per your flooring manufacturer’s recommendations
  • Check the concrete for moisture content
    Note: test methods vary; follow your manufacturer’s recommendation
  • Cut the bottom of door frames enough to allow tiles to fit underneath
  • Make sure the concrete is clean, dry, smooth and level prior to beginning the installationNote: having a smooth sub-surface is very important for glued-down tiles – the shape of imperfections in the concrete or loose debris left behind will be seen and felt in the finished surface
  • Apply sub-floor primer to the concrete with a roller and allow to dry prior to applying adhesive

Preparation for installation on wood or hardboard:

  • Repair any uneven areas
  • Check moisture content of the sub-floor according to the manufacturer’s recommendations
  • If sub-flooring is over a crawlspace, cover the ground below the sub-floor with polyethylene sheeting
    Note: most manufacturers recommend 6-mil sheets overlapped and taped together
  • Cut the bottom of door frames enough to allow tiles to fit underneath
  • As with concrete, make sure the sub-floor is level, clean and most importantly, smooth to prevent any irregular shape transfer through the cork
  • Apply sub-floor primer with a roller and allow to dry prior to applying adhesive

Acclimation:

  • Most manufacturers recommend acclimating cork tiles for 2-3 days, at normal-living temperature and humidity levels, and in the room where the tiles will be installed
    Note: refer to your flooring manufacturer’s documentation for specific details
  • Apply the recommended adhesive to the sub-floor with a roller, working in small areas at a time, and allow it to dry

Installation of tiles:

  • Since cork has natural variations in shade and pattern, sort through the boxes and select tiles that will provide the best overall look
  • Using spacers, leave an expansion space around the border of the room and around any fixed objects, like pipes and kitchen islands
    Note: refer to your manufacturer’s instructions since expansion space recommendations can vary from 1/4 in. to 1/2 in.
  • Apply pressure equally across the surface of each tile as it is laid in place
  • After all tiles are in place, and prior to applying sealer, roll the entire floor according to the manufacturer’s recommendations
  • Allow the adhesive to dry completely before walking on the floor
    Note: the typical recommendation is 24 hours, but this could vary depending on climatic conditions
  • Clean the finished floor with a polyurethane cleaner then seal it with a urethane sealer, as recommended by the manufacturer

Always follow your flooring manufacturer’s recommendations and the end result will be a beautiful new cork floor that you’ll be proud to show off for years to come.